上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
83 / 131
5.8 Add Cooling Points
This operation is used to add cooling points at the inflection points on the objects, so
as to improve the cutting effect during cutting a thick plate.
To add cooling points, do one of the following:
• Automatically add cooling points.
Used to automatically add cooling points to the selected and qualified objects
according to the set value.
• Manually add cooling points.
Used to manually add cooling points at the corners of the object based on your
need, and the range of the angle is (0, 180)°.
Note: Do not add a cooling point at the machining start position.
5.8.1 Automatically Add Cooling Points
To automatically add cooling points, do the following:
1. Select the target objects.
2. Click Object → Special Technics → Cooling Point. Cooling Point dialog box
pops up:
3. Set the range of the acute angle.
4. Optional: To add a cooling point at the position of lead-in line without being
limited by the range of the acute angle, check Lead point.
To Next Page
Loading...
