上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
84 / 131
Taking the following figure as an example, set Sharp Corner between 45 and 90.
The system adds cooling points automatically:
5.8.2 Manually Add Cooling Points
To manually add cooling points, do the following:
1. Open Cooling Point dialog box.
2. Click By Mouse. The cursor turns into .
3. Move the mouse to the target position and left click to select an adding position.
If you need to exit adding cooling points, right click the mouse.
Result of manually adding cooling points shows as follows:
To Next Page
Loading...
