上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
25 / 131
2.5.2 Manually Find Edges
Before manually finding edges, click to turn on red light, so as to guide the
locating position.
To manually find edges, do the following:
1. In Edge Finding dialog box, click Manual to switch to manual edge finding
interface:
2. To specify upper right/lower right/upper left/lower left point on the sheet as
the origin O’ of the new WCS, select a point in O Position.
You can check the diagram in Three-point area to check the situation of point
O relative to point O’.
To Next Page
Loading...
