上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
24 / 131
2. Set edge finding parameters.
3. Manually move the cutting head to the sheet.
4. Optional: If it is your first time to find edges, click Save As Start Point to
record the machine coordinate of the edge finding start point, and check Start
from edge finding start point. The system starts to find edges from the
recorded start point by default.
5. To start to find edges automatically, click Start.
The system judges the long edge and the short edge according to the set value
of parameter Sheet Size.
6. Optional: Check Return to O’ after edge finding. The cutting head returns to
point O’ automatically after automatically finding edges.
The system starts to automatically find edges as follows:
1. Locate point C:
1. Enable follow at the current position.
2. Move towards the short edge at Finding Speed. The out point is point C.
2. Locate point A:
1. Enable follow at the position which is 20% away from the long edge.
2. Move towards the long edge. The out point is point A.
3. Locate point B:
1. Enable follow at another position which is 20% away from the long
edge.
2. Move towards the long edge. The out point is point B.
To Next Page
Loading...
