上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
23 / 131
After starting edge finding, prompt Inclined angle in current edge finding: X.XXX
deg shows on the upper left of drawing window.
2.5.1 Automatically Find Edges
The origin O’ of the new WCS is the berth point and setting out directions along the
sheet edges are the sheet edges close to selected berth point.
Relationship between the berth point and setting out directions along the sheet
edges is as follows:
Before automatically finding edges, ensure the berth point is upper right/lower
right/upper left/lower left. See Set the Workpiece Origin for details.
To automatically find edges, do the following:
1. In Edge Finding dialog box, click Auto to switch to automatic edge finding
interface:
To Next Page
Loading...
