上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
104 / 131
Cut Height
The distance between the nozzle and the material during cutting.
Cut Focus
The position of focus during cutting.
It takes effect after enabling focus control.
See Control Focus for details.
6.5.2 Piercing Parameters
Increment S
The speed of the cutting head during falling from the piercing height to the cutting
height during increment piercing.
Peak Power
The laser intensity during cutting when the laser device is adjusted via the analog
quantity.
Pierce Frequency
The carrier frequency of PWM modulate signals during piercing.
In general, it is set relatively lower and pulse is used to avoid bad piercing.
Duty Cycle
In per unit pulse cycle, the ratio of light output time to the unit pulse cycle time.
You can adjust the laser device via PWM to set duty cycle during piercing.
Pierce Pressure
The pressure of auxiliary gas during piercing.
It should be used together with proportional valve or multi-valve.
Pierce Gas
The used auxiliary gas during piercing.
Pierce Height
The distance between the piercing position and the material.
Punch Focus
The position of focus during piercing.
It takes effect after enabling focus control.
See Control Focus for details.
Pierce Delay
The duration of laser on at piercing height during increment piercing and segment
piercing.
To Next Page
Loading...
