上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
99 / 131
2. Do one of the following:
– Adjust the power curve on the curve:
• To add a node, double click the target position.
• To delete a node, double click the target node.
• To modify a node, double click the target position over/under the
node.
Corresponding speed and power values are added/deleted/modified in
the right table synchronously.
– Adjust the power curve by editing in the table:
• To add a group of speed and power values, click Add, and double
click to modify the values.
• To delete a group of speed and power values, select the values
and click Delete.
• To modify a group of speed and power values, double click and
modify the values.
Corresponding node is added/deleted/modified on the left curve
synchronously.
The more nodes are added, the more precise the curve is.
If you need to restore the curve to default, click Clear.
6.2.3 Add Technic Remarks
This operation is used to make notes for machining information, so that the system
automatically generates name of the technic file when you save layer technics.
To add technic remark, enter remark information in Remarks area.
6.2.4 Save Layer Technics
To save layer technics, do one of the following:
• Click Save. The layer technics are saved into the technic library for backup.
• Click Save As. The layer technics are saved as a LTP file.
If you need to use the saved layer technics, click Import to import a LTP file.
To Next Page
Loading...
