上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
33 / 131
3. Select a centering method:
– Simple Center: only centering the tube.
– Leveling + Four-face centering: execute leveling and centering the
tube.
4. Set parameter Centering Interval / Leveling Centering Interval.
When the Y-axis length of a cutting object exceeds the value, the system
automatically starts to level and center the tube according to the selected
centering method, then executes breakpoint resume to continue cutting.
To Next Page
Loading...
