Maintenance
0380−1/A1
Winterthur Gas & Diesel Ltd.
9/ 11
Group Component Procedure Intervals and Service
Life (operation hours)
6606−1 Scavenge air
cooler
− Clean the scavenge air cooler (air side) during
operation each week. Later if np (pressure
decrease through the SAC) increases
compared to the shop test value at the same
engine load (refer to the Operation Manual
6606−1)
As necessary
− Do a check of the condensate collector
through the sight glass (refer to the Operation
Manual 8345−1)
Daily
− Make sure that the condensate collector is not
blocked (refer to the Operation Manual
8345−1)
1500 to 3000
− Check scavenge air cooler sealing Quarterly
− Bleed Daily
− Remove the scavenge air cooler for overhaul As necessary
6708−1 Water separator
scavenge air
− Do a check of the condensate collector
through the sight glass (refer to the Operating
Manual 8345−1)
Daily
− Make sure that the condensate collector is not
blocked (refer to the Operating Manual
8345−1)
1500 to 3000
− Do a check of the the water separator
elements (if necessary clean them)
1500 to 3000
− Remove the water separator for overhaul As necessary
7
7218−1 Cylinder
Lubricating
pump
− Re−manufacture cylinder lubricating pump or
overhaul on board
45000
Filter
replacement
− Replace the filter element upstream of the the
cylinder lubricating system
As necessary
− Estimated service life: Cylinder lubricating
pump
30000
8
8135−1
Exhaust Waste
Gate (LLT)
− General inspection. During a longer operation
period at low engine load, manually open the
butterfly valve a minimum of one time each
week (refer to the Operation Manual 8135−1)
In accordance with the
instructions of the valve
manufacturer
Servo oil service
pump (engine
mounted)
− Do a check of the flow rate and maximum
pressure
30000
Starting air
pipes on and
before the
engine
− Drain (remove water) Before and after each
maneuvering period
Inspection and Overhaul Intervals (Guidelines)
2020
To Next Page
Loading...