Maintenance
2708−1/A1
Winterthur Gas & Diesel Ltd.
5/ 5
6. Completion
1) Install the expansion piece, refer to 2751−1, paragraph 4.
2) Install the hydraulic pipe to the exhaust valve, refer to 8460−1.
3) Install the HP fuel pipe, refer to 8733−1.
4) Install the applicable HP pilot fuel pipes, refer to 8790−1.
5) Connect the cooling water pipe.
6) Connect the electrical connections to all injectors.
7) Connect all connections to cylinder cover and exhaust valve.
8) Connect the starting air pipe.
9) Open the valves you closed before (one valve each time) and do a check for
leaks.
10) Connect all other connections to the cylinder cover and exhaust valve.
11) Fill the cylinder cooling water system.
12) Set to on the cooling water pump
13) Make sure that cooling water is at the usual operation pressure and temperature.
14) Do a check for leaks.
15) Remove all tools and equipment from the work area.
2016
Cylinder Cover and Water Guide Jacket − Removal and Installation
To Next Page
Loading...