Maintenance
3603−1/A1
Winterthur Gas & Diesel Ltd.
1/ 3
Inner Pipe − Removal and Installation
Tools:
1 Lifting tool 94337
1 Centering piece 94337A
1 Flange 94337B
1. Removal
WARNING
Injury Hazard: Before you operate the turning gear, make sure
that no personnel are near the flywheel, or in the engine.
1) Operate the turning gear to move the applicable crank approximately 30_ after
TDC.
2) Remove the oil inlet pipe (1, Fig. 1) from the piston cooling and crosshead
lubrication.
3) Attach the lifting tool (94337) to the inner pipe (2) and the engine room crane (3).
013.398/05
013.399/05
013.400/05
94337
2
3
1
I
I
II
Fig. 1
Note: For View II,
see Fig. 2.
2016
Piston Cooling and Crosshead Lubrication
To Next Page
Loading...