Xerox 8850 - Page 106

03/2003
4-30
8850/ 510DP
REP 8.2
Repairs and Adjustments
5. (Figure 2): Remove the Fuser Drive Gear from the Printer.
Figure 2 Removing the Fuser Drive Gear from the Printer
6. (Figure 3): Remove the following connectors and ground strap from the left of the Media
Transport Module (view from paper feed side of Printer).
Figure 3 Disconnecting the Connectors
1
Remove the grip ring from the Fuser
Drive Shaft
2
Slide the Fuser Drive Gear off
the Drive Shaft
5
Disconnect P/J A21P1
4
Disconnect the two wire connectors
3
Disconnect the
ground strap
2
Remove the Bias
Transfer Roll to pre-
vent it from falling out
and damaging the roll
1
Remove the
Media Guides