FRU Disassembly 8-35
1. Remove the Stacker if installed.
2. Remove the Print Cartridge and leave the Top Cover open.
3. Remove both paper cassettes (Trays 1 and 2).
4. Remove any optional 500-Sheet Feeder(s) (page 8-93).
5. Remove the Paper Exit Rear Door (page 8-5).
6. Remove the Fuser Assembly (page 8-54).
7. Lay the printer on its left side.
8. Lift the boss of the Left Holder at the back of the 550-Sheet Feeder Assembly,
then shift the Left Holder in the direction of the arrow to release the three hooks.
9. Remove the Left Holder and No Paper Actuator from the Nudger Support.
10. Release the hook retaining the Nudger Roller, and slide it off the Nudger Shaft.
11. Release the hook retaining the Nudger Gear, and slide it off the Nudger Shaft.
Replacement Note:
â– After the No Paper Actuator is replaced, manually operate it to verify that it
moves smoothly.
To Next Page
Loading...
Need help?
General