8-40 Phaser 4500 Service Manual
5. Lift the latch and shift the Right Tray Guide back and up as indicated by the
arrow in the figure. Separate the Right Tray Guide from the frame.
6. Release the wire harness from the rear of the Right Tray Guide.
7. Unplug the connector (P/J260) of the Low-Paper Sensor Harness from the Right
Tray Guide.
Replacement Notes:
■ After re-connecting P/J260, make sure the Low-Paper Sensor Harness is
properly looped through the two harness retainers.
■ When installing the Right Tray Guide, be sure to position the Cassette Lock
Plates as shown in the figure.
To Next Page
Loading...
