FRU Disassembly 8-59
1. Remove the Fuser Assembly (page 8-54).
2. Remove the Transfer Roller Assembly (page 8-55).
3. Remove the Front Duct (page 8-44).
4. Remove the Image Processor Shield Assembly (page 8-86).
5. Remove the HVPS Shield Plate (page 8-88).
6. Unplug the HV connector, J31 from P31 on the HVPS/Engine Logic Board.
7. Unplug J15 from P15 on the HVPS/Engine Logic Board.
8. Remove the three screws (silver machine, 6 mm) that attach the Print Cartridge
Right Guide Assembly to the frame.
9. Pull the wiring harness of the Print Cartridge Right Guide Assembly from the
frame.
10. Remove the Print Cartridge Right Guide Assembly.
To Next Page
Loading...
Need help?
General