FRU Disassembly 8-79
1. Remove the Front Cover (page 8-12).
2. Remove the LVPS Shield Plate (page 8-75).
Caution
Do not attempt to unplug the cables from J101 or J104 on the LVPS. These
are soldered connections and attempts to disconnect the wires will damage
the circuit board.
3. Disconnect the harness connector from P101 on the Exit Motor PWBA.
4. Unplug the inline harness connector at P/J 404.
5. Disconnect the harness connectors from the connectors (P/J40, 41, 42, 43, 44, 45,
46, 47 and 48) on the LVPS.
6. Remove the five screws (silver, 6 mm) that attach the LVPS to the frame.
7. Remove the LVPS.
To Next Page
Loading...
Need help?
General