Xerox Phaser 4500 Service Manual

8-92 Phaser 4500 Service Manual
2. Remove the Image Processor Shield Assembly (page 8-86).
3. Unplug the ribbon cable from J800 (the connector to the HVPS/Engine Logic
Board). Be sure to note the orientation of the blue stripe on the ribbon.
4. Unplug the cables at J110 and J130 (at the top of the board).
5. Remove the four screws that attach the Rear Panel to the printer frame.
6. Remove the five board mounting screws (silver machine, 6 mm) and lift out the
board with the Rear Panel attached.
7. Remove the memory DIMM(s).
8. Remove the optional Flash Memory (if present)
9. Remove the optional Hard Drive (if present).
10. Remove the socketed NVRAM (U660).
11. Remove the Configuration Card securing bracket.
12. Unplug the Configuration Card.
13. Remove the two screws (silver machine, 10 mm) that attach the parallel
connector to the Rear Panel, and the screw (silver machine, 6 mm) that attaches
the USB connector to the Rear Panel
14. Separate the Rear Panel from the I/P Board.
Replacement Note:
■ The Configuration Card, memory DIMM(s), Flash Memory (if present),
NVRAM, and Hard Drive (if present) must be transferred to the replacement
I/P Board.

Xerox Phaser 4500 Specifications

General

Brand	Xerox
Model	Phaser 4500
Category	Printer
Language	English