FRU Disassembly 8-101
3. Remove the Rear Cover (steps 1 and 2 in “550-Sheet Feeder” on page 8-104).
4. Disconnect the Feeder Motor Harness (J820) from P820 (located at the rear of the
550-Sheet Feeder Assembly).
5. Remove the three screws at the left end of the 550-Sheet Feeder (page 8-104).
6. Remove the three screws (two gold tapping, 8 mm; one silver machine, 6 mm)
that attach the Optional Feeder Drive Assembly to the 550 Left Cover Frame.
7. Lift the left end of the Optional 550-Sheet Feeder to provide enough clearance
while removing the Optional Feeder Drive Assembly.
Replacement Notes:
Caution
Be careful to not pinch wires during re-assembly.
■ Be sure to return the machine screw (silver, 6 mm) to the location shown at
“Screw (A)” in the figure.
■ When installing the Left Cover Plate, be sure to install the tip of the
Grounding Plate under the Left Cover Plate.
To Next Page
Loading...
Need help?
General