FRU Disassembly 8-105
1. Remove the five screws (gold tapping, 8 mm) that attach the Feeder Rear Cover
to the frame.
2. Remove the Feeder Rear Cover.
Note
The three connectors in the following step have gender adapters that could
stay with either side of the harness.
3. Disconnect the three wiring harness connectors (P/J801, P/J820, and P/J855)
exposed behind the Rear Cover.
4. Release release the wiring harnesses from the four harness clamps.
5. Remove the six screws (gold tapping, 8 mm) that attach the optional 550-Sheet
Paper Feeder to the frame.
6. Remove the optional 550-Sheet Paper Feeder from the frame.
To Next Page
Loading...
Need help?
General