FRU Disassembly 8-147
1. Remove the Stacker Rear Cover (page 8-133).
2. Remove the Stacker Cover (page 8-134).
3. Remove the Stacker Front Cover (page 8-137).
4. Shift the Stacker Actuator in the direction of the arrows to release the pivots from
the hooks on both sides.
Note
Carefully observe the orientation of the actuator spring for reference when
reassembling.
5. Unplug Stacker Sensor Harness (J730) from the Stacker Sensor.
6. Release the hooks of the Stacker Sensor, and remove it from the Stacker Housing.
To Next Page
Loading...
