Error Messages and Codes 3-15
Controller NVRAM Access
This menu allows you to reset the PostScript NVRAM locations to factory defaults.
Reset PostScript NVRAM Resets the PS NVRAM. You are prompted to confirm
your decision to perform a reset operation.
Factory Reset NVRAM Allows you to reset the PS NVRAM locations to factory
defaults. This tests is password protected to allow access only to certified Service
Personnel. The password to access the reset functions is 4370. To enter the password,
you use the OK button to move from digit to digit on the display, you use the Up and
Down Arrow buttons the change the value of the digit, and when the password is
correct, you use the Back button to enter the selection. After you enter the password,
you are prompted to confirm your decision to perform a reset operation.
Exit
Reboots the Printer out of Service Diagnostics
To Next Page
Loading...
Need help?
General