Phaser 6130 Color Laser Printer Service Manual 3-41
Error Messages and Codes
27 Check the power to the Drive Clutch
Assy
Disconnect J26 from the MCU Board.
Is the voltage across P26-4pin <=>
ground on the MCU Board, about +24
VDC when the Interlock Switch (HARN
ASSY INTERLOCK) is pushed?
Go to step 28. Replace the
MCU Board
(page 8-59).
28 Check the Drive Clutch Assy for
resistance
Disconnect P/J262 of the Drive Clutch
Assy.
Is the resistance across J262-1 and
J262-2 approximately 280-ohm?
Replace the
MCU Board
(page 8-59).
Replace the
Drive Clutch Kit.
(page 8-21)
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No
To Next Page
Loading...
