4-28 Phaser 6130 Color Laser Printer Service Manual
General Troubleshooting
Sub Motor (FULL2/FULL1/HALF)
The Sub Motor is located in the Main Drive and drives the Fuser and
Developer.
Caution
If the front cover will be open for more than 5 minutes, remove the
Imaging Unit and cover it or place it in a dark location to avoid exposure to
light.
o
e
The rotational speed order of the of the Sub Motor test is as follows:
■ FULL2 < FULL1 < HALF
1. Enter the Service Diagnostic menu (page 4-5).
2. Open the Front Cover.
3. Defeat the Interlock Switch.
4. Perform the Sub Motor FULL2/FULL1/HALF test: Engine Diag > Motor
Test > Sub Motor FULL2/FULL1/HALF.
5. Verify that the Sub Motor is running and the Exit Roller is rotating.
6. Press the Cancel button to stop the Sub Motor test.
7. Remove the paper clip from the Interlock Switch.
s6130-192
Exit Roller
To Next Page
Loading...
