Yamaha 200A - Removing the Crankcase

60H5E11
Power unit
POWR
Removing the crankcase
1. Remove the bearing housing.
2. Remove the O-ring, oil seal, and needle
bearing from the bearing housing.
60H50370
NOTE:
Once removed, oil seal and needle bearing
must be replaced with the new one.
3. Install a new needle bearing into the bear-
ing housing.
60H50380
AA
AA
E
Ball bearing attachment :
90890-06663
Driver rod LS : 90890-06606
Bearing inner race attachment :
90890-06661
Needle bearing attachment 1:
90890-06654
Driver rod L3 : 90890-06652
2
5-27
Ball bearing attachment 3:
90890-06637
Bearing outer race attachment 4:
90890-06624
Driver rod LS : 90890-06606
3
4
4. Install a new O-ring and a new oil seal into
the bearing housing.
60H50390
5. Remove the oil seal housing.
6. Remove the O-ring and oil seal.
7. Install a new O-ring and a new oil seal.
60H50410
AA