Yamaha 200A - Removing and Installing the Steering Arm

60H5E11
7
Removing the steering arm
1. Remove the circlip 1.
2. Remove the steering yoke 2 by striking it
with a plastic hammer or the like.
60h71170
3. Pull off the steering arm, and remove the
washer, O-ring, and bushing.
Installing the steering arm
1. Install the washer and bushing onto the
steering arm.
2. Place the swivel bracket in the upright po-
sition, and insert the steering arm into the
swivel bracket.
60h71180
3. Install the bushing, O-ring, and washer.
Also install the steering yoke.
60h71190
60h71200
NOTE:
Make sure that the orientation of steering yoke
A and steering arm B is consistent at the time
of installation.
4. Install the circlip.
Steering arm
7-42