60H5E11
6
E
Bearing separator 1:
90890-06534
Bearing inner race attachment 2:
90890-06639
Needle bearing attachment 1:
90890-06612
Bearing depth plate 2: 90890-06603
Driver rod SS 3: 90890-06604
Installation depth A:
20.95 - 21.45 mm(0.8248 - 0.8445 in)
Installation depth B:
4.45 - 4.95 mm (0.1752 - 0.1949 in)
Checking the forward gear
1. Check the teeth and dogs of the forward
gear for cracks or wear. Also check the
bearing for run-out or roughness. Disas-
semble them if necessary.
2. Remove the bearing.
60h60370
NOTE:
When the taper roller bearing is removed, al-
ways replace it with a new one.
3. Remove the needle bearing.
60h60380
NOTE:
When the needle bearing is removed, always
replace it with a new one.
Assembling the forward gear
1. Install the needle bearing.
60h60390
2. Install a new taper roller bearing.
60h60400
NOTE:
Shimming is required when the taper roller
bearing is replaced. Record the measured
height of the new taper roller bearing.
Drive shaft and lower case (regular rotation model)
6-20
Bearing inner race attachment 4:
90890-06660
E
To Next Page
