Yamaha 200A - Checking the Plug Cap (with Resister Type)

60H5E11
8
Spark plug cap resistance :
4.0 - 6.0 kΩ
3
8-10
Ignition system
2. Remove the spark plug cap 1, and remove
the plug cap spring 3 from the spark plug
wire 2.
60h80123
3. Cut to remove the insulation A on the spark
plug wire 2 by approximately 5mm from
the wire end.
60h80125
4. Press-in the plug cap spring 3 until it
touches the spark plug wire 2 conductor.
Then bent B as shown.
60h80127
Checking the plug cap
(with resister type)
1. Remove the spark plug cap 1 from the
spark plug wire 2 by turning the cap coun-
terclockwise.
60h80130
2. Measure the spark plug cap 1 resistance.
60h80135
3. Replace the plug cap 1 if the resistance is
out of specification.
4. Install the spark plug cap 1 on the spark
plug wire 2 by turning the cap clockwise.