Yamaha 200A - Assembling Power Trim and Tilt Unit

60H5E11
7
60h70900
Assembling the power trim and tilt unit
1. Fill the tilt cylinders with the fluid.
60h70920
NOTE:
Fill the tilt cylinders with the specified quantity
of recommended fluid through the hole A.
2. Push-in the free piston 1 to the bottom of
tilt cylinder.
60h70930
Recommended power trim and tilt
fluid:
ATF Dexron II
Specified quantity:
30 cm
3
(1.1 Imp oz)
Tilt piston nut:
96 N • m (9.6 kgf • m, 71 ft • lb)
T
R
.
.
60H70880
60H70890
14
15
16
A
60H70930
1
10. Install the tilt cylinder end cap 4 on the tilt
rod 5.
60h70870
11. Install a new O-ring 67 on the tilt piston
8. Also install the ball 9, absorber pin 0,
and spring A in this order.
12.Install the tilt piston sub-assembly and
washer B on the tilt rod 5, and tighten the
nuts C.
60h70880
13. Install new backup ring E and the O-ring
F on the free piston D.
60h70890
14. Install new oil seal G, dust seal H, backup
ring I, and O-ring J, K on the trim cylin-
der end cap and the trim piston.
Tilt cylinder and trim cylinder
7-36