Yamaha 200A - Page 216

60H5E11
Bracket unit
BRKT
7-35
Filter plug:
6 N • m(0.6 kgf • m, 4 ft • lb)
T
R
.
.
AA
2. Check the tilt piston and free piston for
scratches. Replace if necessary.
60h70800
3. Air blow the contamination on the tilt pis-
ton absorber valve. Check the valve for
wear, and check the spring for deteriora-
tion.
60h70810
4. Check the tilt rod for bends or corrosion.
Replace if necessary.
60h70820
5. Check the trim piston for scratches. Re-
place if necessary. Check the trim rods for
bends or corrosion. Replace if necessary.
60h70830
6. Remove the filter plug and filter from the
tilt cylinder, and check them.
7. Check the inner walls of tilt cylinder and
trim cylinder for scratches. Replace if nec-
essary.
60h70850
8. Install the filter and filter plug on the tilt cyl-
inder.
9. Install a new O-ring 23 and the dust seal
1 on the tilt cylinder end cap.
60h70860