4. Check:
• Wheel bearings
Front wheel tur
ns
roughly
or
is loose
-t
Re-
place the wheel bear
in
gs
.
• O
il
seal
Damage/wear
-t
Replace.
ASS
EMBLIN
G T
HE
FR
O
NT
WHEEL
1 . Install:
• Wheel bearings
l~tiWJ
• O
il
sea
ls
lf@j
••••••••••••••••••••••••••••••••
a. Install the new wheel bearing (right side).
£CA1RC\408
NOTICE
~~~~~~~~~~~~~
Do not contact the wheel bearing inner race
"1" or balls
"2". Contact should
be
made
only with the outer race
"3".
TIP
~~~~~~~~~~~~~~-
Use a socket "4" that
ma
tches the diameter of
the wheel bearing outer race.
+
b. Install the spacer.
4-11
FRONT WHEEL
c. Insta
ll
the new wheel bear
in
g (left side).
T
I
P
~~~~~~~~~~~~~~
Place a suitable washer "1" between the socket
"2" and the bea
rin
g so that both the inner race
"3" and outer race "4" are pressed
at
the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
+
d. Insta
ll
the new oil seal
s.
EAS21970
ADJU
S
TING
TH
E
FRONT
WH
EE
L S
TAT
IC
BALAN
CE
TIP
~~~~~~~~~~~~~~~
• After replacing the tire, wheel
or
both, the front
wheel static
ba
lance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1.
Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
T
I
P
~~~~~~~~~~~~~~
Place the front wheel
on
a suitable balancing
stand.
• •••••••••••••••••••••••••••••••
a. Spin the front whee
l.
b.
When the front wheel stops, put an "X
1
"
mark
at
the bott
om
of
the wheel.
c. Turn the
fr
on
t wheel
90
°
so
that the "X
i"
mark
is positioned as shown.
To Next Page
Loading...
