YASKAWA E-V-MD Series - Page 314

11.3 Parameter Recording Table
11-31
11
Appendix
Pn592 0000
Input Signal Selection
(/DEC Signal Assignment)
After restart
Pn593 0000
Input Signal Selection
(/EXT1 Signal Assignment)
After restart
Pn594 0000
Input Signal Selection
(/EXT2 Signal Assignment)
After restart
Pn595 0000
Input Signal Selection
(/EXT3 Signal Assignment)
After restart
Pn596 0000
Output Signal Selection
(/BK Signal Assignment)
After restart
Pn800 1040 Communications Control Immediately
Pn820 0 Forward Latching Allowable Area Immediately
Pn822 0 Reverse Latching Allowable Area Immediately
Pn824 0000 Option Monitor 1 Selection Immediately
Pn825 0000 Option Monitor 2 Selection Immediately
Pn829 0
SVOFF Waiting Time
(SVOFF at deceleration to stop)
Immediately
Pn840 100
Linear Deceleration Constant 2 for
Stopping
Immediately
∗ 2
Pn846 0
POSING Command S-curve
Acceleration/Deceleration Rate
Immediately
Pn880 3 Station Address Setting After restart
Pn881 48 Number of Transmission Bytes After restart
01
PnA02
– Encoder Type (read only) –
02
PnA04
– Motor Type (read only) –
03
PnA06
– Reserved (Do not use.) –
04
PnA08
– Rated Speed (read only) –
05
PnA0A
– Maximum Output Speed (read only) –
06
PnA0C
– Speed Multiplier (read only) –
07
PnA0E
– Rated Torque (read only) –
08
PnA10
– Maximum Output Torque (read only) –
09
PnA12
– Torque Multiplier (read only) –
0A
PnA14
– Resolution (read only) –
0B
PnA16
–Scale Pitch
0C
PnA18
– Pulses per Scale Pitch After restart
∗2. Change the setting when the reference is stopped (DEN is set to 1), because the change will affect the output during
operation.
Note: When using parameters that are enabled after restarting the SERVOPACK, a CONFIG command must be input or
the power must be turned OFF and then ON again.
(cont’d)
Parameter
Factory
Setting
Name
When
Enabled