YASKAWA LA500 - Change Parameter Settings; Save a Backup of Parameters

4.9 Keypad Operation
102 YASKAWA SIEPYEULA5001C LA500 Technical Manual
Figure 4.22 Set and View Quick Setup Parameters
Continue to change the parameters or press and hold to go back to the frequency reference screen.
◆ Change Parameter Settings
Show the frequency reference screen in advance.
Note:
Push and hold to go back to the frequency reference screen from any screen.
This example shows how to change C1-01 [Acceleration Time 1]. Set the parameter to the necessary value.
Figure 4.23 How to Change the Parameter Setting
Continue to change parameters or push and hold to go back to the frequency reference screen.
◆ Save a Backup of Parameters
Show the frequency reference screen in advance.
Note:
Push and hold to go back to the frequency reference screen from any screen.
Use these steps to save a backup of the drive parameters to the keypad.
Making backups of the parameter settings can save time when setting parameters after replacing a drive. If you set
up more than one drive, you can copy the parameter settings from a drive that completed a test run to the other
drives.
Note:
• Make sure that you stop the motor before you back up parameters.
• The drive does not accept Run commands while it is making a backup.
• Set o3-02 = 0 [Copy Allowed Selection = Disabled] to protect the parameters saved in the keypad.