Mechanical Installation
2
2.8 Install the Keypad in a Control Panel or Another Device
YASKAWA SIEPYEULA5001C LA500 Technical Manual 37
2.8 Install the Keypad in a Control Panel or Another Device
◆ Operate the Keypad from a Remote Location
You can remove the keypad from the drive and connect it to a remote control extension cable 3 m (9.8 ft) long to
make operation easier when you cannot access the drive. It is not necessary to open or close the panel door to
operate a drive that is in a control panel. To order optional accessories, contact Yaskawa or your nearest sales
representative.
Name Option Model Intended Use
Keypad Remote Cable
WV001: 1 m (3.3 ft)
WV003: 3 m (9.8 ft)
To connect the keypad and drive.
This option is an RJ-45, 8-pin straight-through UTP CAT5e cable.
Installation Support Set A 900-192-933-001
To attach the keypad to the control panel. This option uses screws.
Installation Support Set B 900-192-933-002
To attach the keypad to the control panel. This option uses nut clamps.
Use this option when weld studs are located in the control panel.
To Next Page
Loading...
