YASKAWA LA500 - Warning Label Content and Location

i.1 Using the Product Safely
14 YASKAWA SIEPYEULA5001C LA500 Technical Manual
NOTICE
Use an inverter-duty motor or vector-duty motor with reinforced insulation and windings
applicable for use with an AC drive.
If the motor does not have the correct insulation, it can cause a short circuit or ground fault from insulation
deterioration.
Damage to Equipment
When you touch the drive and circuit boards, make sure that you observe correct electrostatic
discharge (ESD) procedures.
If you do not follow procedures, it can cause ESD damage to the drive circuitry.
Do not do a withstand voltage test or use a megohmmeter or megger insulation tester on the
drive.
These tests can cause damage to the drive.
Do not operate a drive or connected equipment that has damaged or missing parts.
You can cause damage to the drive and connected equipment.
Do not use steam or other disinfectants to fumigate wood for packaging the drive. Use
alternative methods, for example heat treatment, before you package the components.
Gas from wood packaging fumigated with halogen disinfectants, for example fluorine, chlorine, bromine, iodine
or DOP gas (phthalic acid ester), can cause damage to the drive.
◆ Warning Label Content and Location
The drive warning label is in the location shown in Figure i.1. Use the drive as specified by this information.
Replace unreadable or missing labels.
A - Warning label “Hot surface”
B - Nameplate
C - Warning label “Risk of electric shock”
D - Warning label “Application”
Figure i.1 Warning Label Content and Location
The labels show the following content:
Figure i.2 Warning Label “Hot surface”
Figure i.3 Warning Label “Risk of electric shock”