Parameter Details
12
12.6 H: Terminal Function Selection
YASKAWA SIEPYEULA5001C LA500 Technical Manual 305
■ H1-06: Terminal S6 Function Selection
No.
(Hex.)
Name Description
Default
(Range)
H1-06
(0403)
Terminal S6 Function
Selection
Sets the function for MFDI terminal S6.
53
(3 - 79)
■ H1-07: Terminal S7 Function Selection
No.
(Hex.)
Name Description
Default
(Range)
H1-07
(0404)
Terminal S7 Function
Selection
Sets the function for MFDI terminal S7.
F
(3 - 79)
◆ MFDI Setting Values
Selects a function for MFDI.
■ 3: Multi-Step Speed Reference 1
Setting Value Function Description
3 Multi-Step Speed Reference
1
Uses speed references d1-01 to d1-08 to set a multi-step speed reference.
■ 4: Multi-Step Speed Reference 2
Setting Value Function Description
4 Multi-Step Speed Reference
2
Uses speed references d1-01 to d1-08 to set a multi-step speed reference.
■ 5: Multi-Step Speed Reference 3
Setting Value Function Description
5 Multi-Step Speed Reference
3
Uses speed references d1-01 to d1-08 to set a multi-step speed reference.
■ 7: Accel/Decel Time Selection 1
Setting Value Function Description
7 Accel/Decel Time Selection
1
Sets the drive to use Acceleration/Deceleration Time 1 [C1-01, C1-02] or Acceleration/Deceleration Time 2 [C1-03, C1-04].
Note:
Refer to C1: Accel & Decel Speed on page 288 for more information.
■ 8: Baseblock Command (N.O.)
Setting Value Function Description
8 Baseblock Command (N.
O.)
Sets the command that stops drive output and coasts the motor to stop when the input is ON.
The keypad flashes bb [Baseblock]. If you cancel the baseblock command when the Run command is active, the
drive will restart the motor and use the speed search function.
WARNING! Sudden Movement Hazard. When you use a mechanical holding brake with the drive, you must close the brake if
an input terminal triggers the Baseblock command to stop drive output. If you enter the baseblock command, the motor will
suddenly coast and the load will slip, which can cause serious injury or death.
To Next Page
Loading...
