3.4 Main Circuit Terminal Block Wiring Procedure
54 YASKAWA SIEPYEULA5001C LA500 Technical Manual
2. Push up the screwdriver to release the IP20 terminal protective cover.
A - IP20 terminal protective cover
Figure 3.16 Release IP20 terminal protective cover
3. Remove IP20 terminal protective cover.
Figure 3.17 Remove IP20 Terminal Protective Cover
■ Wiring the Main Circuit Terminal Block
When terminals R/L1, S/L2, T/L3, and terminal - have IP20 terminal protective covers, remove the cover on the
terminal where you will wire.
1. Put wires with prepared ends into the main circuit terminal block.
Look through the opening in the drive case to make sure that you correctly installed the wires into the
terminal block.
Figure 3.18 Install the Electrical Wire
Note:
There is a jumper between terminals +1 and +2. Remove the jumper, then wire to terminals +1 and +2.
To Next Page
Loading...
