To Next Page

To Previous Page

DataWedge 4 - 17

• I2of5 Security Level - Options: I2of5 Security level 0, I2of5 Security Level 1, I2of5 Security Level 2 and

I2of5 Security Level 3 (default - I2of5 Security level 1).

• Convert ITF-14 To EAN13 - Convert 14-character Interleaved 2 of 5 bar codes to EAN-13, and transmit as

EAN-13. The Interleaved 2 of 5 bar code must be enabled and must have a leading zero and a valid EAN-13

check digit. A check in the checkbox indicates that the option is enabled (default - disabled).

• I2of5 Reduced Quiet Zone - Enables decoding of margin-less I2of5 bar codes.

Matrix 2 of 5

• Length1 - Use to set decode lengths (default - 10). See Decode Lengths on page 4-19 for more information.

• Length2 - Use to set decode lengths (default - 0). See Decode Lengths on page 4-19 for more information.

• Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the checkbox

indicates that redundancy is enabled (default - disabled).

• Report Check Digit - Transmit Matrix 2 of 5 data with or without the check digit. A check in the checkbox

indicates to send Matrix 2 of 5 data with check digit (default - enabled).

• Verify Check Digit - Enable this feature to check the integrity of all Matrix 2 of 5 symbols to verify that the

data complies with a specified check digit algorithm (default - enabled).

MSI

• Check Digit - With MSI symbols, one check digit is mandatory and always verified by the reader. The second

check digit is optional.

• One Check Digit - Verify one check digit (default).

• Two Check Digits - Verify two check digits.

• Check Digit Scheme - Two algorithms are possible for the verification of the second MSI check digit. Select

the algorithm used to encode the check digit.

• Mod-11-10 - First check digit is MOD 11 and second check digit is MOD 10 (default).

• Mod-10-10 - Both check digits are MOD 10.

• Length 1 - Use to set decode lengths (default - 4). See Decode Lengths on page 4-19 for more information.

• Length 2 - Use to set decode lengths (default - 55). See Decode Lengths on page 4-19 for more information.

• Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the checkbox

indicates that redundancy is enabled (default - enabled).

• Report Check Digit - Transmit MSI data with or without the check digit. A check in the checkbox indicates to

send MSI data with check digit (default - disabled).

Trioptic 39

• Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the checkbox

indicates that redundancy is enabled (default - enabled).

UK Postal (RS507)

• Report Check Digit - Transmit UK Postal data with or without the check digit. A check in the checkbox

indicates to send UK Postal data with check digit (default - disabled).

Zebra TC75 Integrator Guide

Other manuals for Zebra TC75