EasyManua.ls Logo

Zebra TC75 - Battery Charging and Management

Zebra TC75
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Getting Started 1 - 9
Figure 1-16 Lift the Battery
9. Insert the replacement battery, bottom first, into the battery compartment in the back of the TC75.
10. Press the battery down until the battery release latch snaps into place.
11. Replace the hand strap, if required.
12. Press and hold the Power button to turn on the TC75.
Replacing the microSD Card
To replace the microSD card:
1. Press the Power button until the menu appears.
2. Touch Power off.
3. Touch OK.
4. If hand strap is attached, slide the hand strap clip up toward the top of the TC75 and then lift.
CAUTION Replace the battery within two minutes. After two minutes the device reboots and data may be lost.

Table of Contents

Other manuals for Zebra TC75

Related product manuals