Zebra TC75 - Connecting to the TC75 as a Camera; Disconnect from the Host Computer

3 - 2 TC75 Integrator Guide
Connecting to the TC75 as a Camera
1. Connect the USB Charge cable to the TC75 and then to the host computer.
Connected as a media device, Connected as an installer or Connected as a camera appears on the
Status bar.
2. If Connected as an installer or Connected as a media device appears, pull down the Notification shade and
touch Connected as an installer or Connected as a media device and then touch Camera (PTP).
3. On the host computer, open a file explorer application.
4. Locate the TC75 as a portable device.
5. Open the SD card or the Internal storage folder.
6. Copy or delete photos as required.
Disconnect from the Host Computer
1. On the host computer, unmount the device.
2. Remove the USB Charging cable from the device.
NOTE Using Camera, you can copy files to either the microSD card or internal memory.
CAUTION Carefully follow the host computer’s instructions to unmount the microSD card and disconnect USB
devices correctly to avoid losing information.