Zmorph FAB - Page 36

Product Manual - ZMORPH FAB back to table of content >>
36
Manual Toolhead change
Single Extruder Toolhead 1.75
 Connect the LEFT cable to the LEFT frame
socket.
 Connect the extruder ‘A’ cable to the ‘A’
plug and the ‘B’ cable to the ‘B’ plug on
the X carriage
 Choose ‘Maintenance’.
 Choose ‘Change tool’.
 Choose ‘3D printing’.
 Choose ‘Single printing’.
 
Laser Toolhead
 Connect the LEFT cable to the LEFT frame
socket and RIGHT cable to the RIGHT
frame socket.
 Choose ‘Maintenance’.
 Choose ‘Change tool’.
 Choose ‘Laser’.
Thick Paste Extruder Toolhead
 Connect the LEFT cable to the LEFT
frame socket.
 Connect the extruder ‘A’ cable to X car-
riage ‘A’ plug.
 Choose ‘Maintenance’.
 Choose ‘Change tool’.
 Choose ‘3D printing’.
 Choose ‘Thickpaste printig
Dual Extruder Toolhead
 Connect the LEFT cable to the LEFT frame
socket and RIGHT cable to the RIGHT
frame socket.
 Connect the extruder ‘A’ cable to the ‘A’
plug and the ‘B’ cable to the ‘B’ plug on
the X carriage.
 Choose ‘Maintenance’.
 Choose ‘Change tool’.
 Choose ‘3D printing’.
 Choose ‘Dual printing’.
 Choose ‘Dual Extruder Toolhead
CNC Milling Toolhead
 Connect the LEFT cable to the LEFT frame
socket.
 Connect the extruder ‘A’ cable to X carriage
‘A’ plug.
 Choose ‘MAINTENANCE’.
 Choose ‘CHANGE TOOL’.
 Choose ‘CNC’.
Maintenance