Zmorph FAB - Page 54

Product Manual - ZMORPH FAB back to table of content >>
54
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
To preheat the extruder, follow these steps.
3D printing workow
Choose the ‘MAINTENANCE’
from the LCD touchscreen
menu.
Choose ‘LOAD FILAMENT’. Choose ‘PARK TOOL’, wait for
the machine to position the
toolhead. When done, choose
‘PLA’ to preheat the material.
 Straighten the tip of the

Wait till extruder reaches the
proper temperature. The yellow
‘TEMPERATURES’ sign will
change colour from yellow to
green.

hole on top of the extruder.
NEW JOB MAINTENANCE
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
LOAD/UNLOAD
PLA
ABS
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
PARK
TOOL
BACK

         
     

NOTE
NOTE