Zmorph FAB - Page 55

Product Manual - ZMORPH FAB back to table of content >>
55

you feel it has been grabbed
by extruder drive gear.
Wait until the material

Tap the feed button again if
necessary.
By tapping the button

can change the amount


3D printing workow
Dual Extruder Toolhead
To preheat the extruder, follow these steps.

from the plastic foil, remove
moisture absorber



roll.
Slide spools on the bar and
place it on the machine.
Choose ‘MAINTENANCE’ from
the LCD touchscreen menu.
Choose ‘LOAD FILAMENT’. Choose ‘PARK TOOL’, wait for
the machine to position the
toolhead. When done, choose
‘PLA’ to preheat the material.
NOTE
NEW JOB MAINTENANCE
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
LOAD/UNLOAD
PLA
ABS
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
PARK
TOOL
BACK