Zmorph FAB - Page 67

Product Manual - ZMORPH FAB back to table of content >>
67
Tap the upper arrow with LEFT
description on the screen



clogging. Repeat if needed.
Tap the upper arrow with RIGHT
description on the screen to


mm to prevent clogging.
Repeat if needed.

into the guide.
Tap the bottom arrow on the


with LEFT description to do
that.

you feel it has been grabbed
by the extruder

out of the nozzle. Tap the
feed button again
if necessary

down arrow with RIGHT
description.
Remove the extruded material.
Choose ‘DONE’ and wait until
the extruder starts printing
again.
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
DONE
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
DONE
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
DONE
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
DONE
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
DONE
Sometimes after clicking ‘DONE’ the machine won’t resume the work, in those cases repeat the
feeding by pressing one more time the ‘LEFT’ down button and after the extruder stops the feeding
process press the ‘DONE’ button.
3D printing workow
NOTE
  
  
     
  