Zoom R24 - Page 81

Input and output of insert and send-return effects
80
Uses of effects and patches Select effect and patch
Patches are selected and adjusted the same way for
both insert and send-return effects.
Select suitable modules from algorithms, edit patch
types and parameters, and save them for use later.
There are some major differences between mak-
ing settings for the two types of effects. For insert
effects, you must select patches and set insertion
points. For send-return effects, you must adjust the
send level of signals using the mixer.
Other functions include IMPORT to bring in patches
from other projects and REC SIG to apply the effect
only to monitoring the playback signal.
The procedures for using effects are the same when
ÕÃ}ÊÌiÊ,Ó{Ê>ÃÊ>ÊÀiVÀ`iÀÊ>`Ê>ÃÊ>Ê>Õ`ÊÌiÀ-
face, but the patches can also be initialized when
the unit is used as an audio interface (INITIAL®°
Send-return effect
Algorithm display name .UMBER OF patches
(preprogram
med patches)
2%6%2"
ÎäÊÓÓ®Ê
#(/253$%,!9
ÎäÊ£n®Ê
Insert effects
Algorithm name Display
name
.UMBER OF PATCHES
(preprogrammed patches)
Clean and crunchy sounds that are suitable for guitars
Clean/Crunch Clean
ÎäÊÓ£®
Overdrive and other distorted sounds suitable for guitars
Distortion Distortion
xäÊ{x®
Instrument simulation algorithm that is suitable for guitars
Aco/Bass SIM Aco/Bass
ÓäÊ£ä®
Algorithm that is suitable for recording bass guitars
Bass Bass
ÎäÊÓä®
Algorithm that is suitable for vocals and other mic recordings
Mic Mic
xäÊÎä®
Algorithm for two completely independent mic channels
Dual Mic Dual Mic
xäÊÎä®
Algorithm for synths, built-in mics and other stereo recording
Stereo Stereo
xäÊ{ä®
Ê}ÀÌÊvÀÊnÊV>iÃÊvÊ`i«i`iÌÊ«ÕÌÊ>`ÊÕÌ«ÕÌÊ
X#OMP %1 X#OMP %1
ÓäÊ£ä®
Algorithm for processing final stereo mix signals
Mastering Mastering
ÎäÊÓ£®
Effect
2
Select ON/OFF and set it to ON.
Change setting
Change menu
1
Press
Select effect type
Press beneath to
select an insert effect.
Press
beneath to
select a reverb send-return effect.
Press
beneath to
select a chorus/delay send-return
effect.
3
Select an algorithm (when setting an
insert effect).
Change
algorithm
Change menu
4
Select a patch.
Change patch
Change menu