Chapter 12 NAT
EMG2306-R10A User’s Guide
101
12.4 The NAT General Screen
Use this screen to enable NAT and set a default server. Click Configuration > Network > NAT to
open the General screen.
Figure 54 Configuration > Network > NAT > General
The following table describes the labels in this screen.
12.5 The NAT Port Forwarding Screen
Port forwarding allows you to define the local servers to which the incoming services will be
forwarded. This screen allows you to create or edit a port forwarding rule. To change your
Table 41 Configuration > Network > NAT > General
LABEL DESCRIPTION
NAT Setup
Enable Network
Address Translation
Network Address Translation (NAT) allows the translation of an Internet protocol
address used within one network (for example a private IP address used in a local
network) to a different IP address known within another network (for example a public
IP address used on the Internet).
Select the check box to enable NAT.
Default Server Setup
Server IP Address In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in the Application
screen.
If you do not assign a Default Server IP address, the EMG2306-R10A discards all
packets received for ports that are not specified in the Application screen or remote
management.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
Need help?
General
