Chapter 18 Remote Management
EMG2306-R10A User’s Guide
124
Click Configuration > Management > Remote MGMT > Telnet to display the screen as shown.
Figure 68 Configuration > Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
18.6 The SNMP Screen
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your EMG2306-R10A supports SNMP agent functionality, which allows a
manager station to manage and monitor the EMG2306-R10A through the network. The EMG2306-
Table 53 Configuration > Management > Remote MGMT > Telnet
LABEL DESCRIPTION
Port You may change the server port number for a service if needed. However you must use
the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the EMG2306-R10A using
this service.
Secured Client IP
Address
Select All to allow all computers to access the EMG2306-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG2306-R10A.
Apply Click Apply to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
