Chapter 8 WAN
EMG2306-R10A User’s Guide
68
8.4.6 Bridge Encapsulation
This screen displays when you select Bridge encapsulation.
Figure 29 Internet Connection: Bridge Encapsulation
The following table describes the labels in this screen.
8.5 Advanced WAN Screen
Use this screen to enable Multicast and enable Auto-IP-Change mode.
To change your EMG2306-R10A’s advanced WAN settings, click Configuration > Network > WAN
> Advanced. The screen appears as shown.
Figure 30 Configuration > Network > WAN > Advanced
Table 19 Internet Connection: Bridge Encapsulation
LABEL DESCRIPTION
ISP Parameters for Internet Access
Encapsulation Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If
you select Bridge, you cannot use routing functions, such as DHCP server.
The function is currently available for the IPv4 protocol.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
Need help?
General
