ZyXEL Communications EMG2306-R10A - The DHCP Advanced Screen

Chapter 11 DHCP Server
EMG2306-R10A User’s Guide
95
11.5 The DHCP Advanced Screen
This screen allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC addresses. You can also use this screen to configure the DNS server information that the
EMG2306-R10A sends to the DHCP clients.
To change your EMG2306-R10A’s static DHCP settings, click Configuration > Network > DHCP
Server > Advanced. The following screen displays.
Figure 50 Configuration > Network > DHCP Server > Advanced
The following table describes the labels in this screen.
Table 38 Configuration > Network > DHCP Server > Advanced
LABEL DESCRIPTION
Static DHCP Table
# This is the index number of the static IP table entry (row).
MAC Address Type the MAC address (with colons) of a computer on your LAN.
IP Address Type the LAN IP address of a computer on your LAN.
DNS Server
DNS Servers
Assigned by DHCP
Server
The EMG2306-R10A passes a DNS (Domain Name System) server IP address (in the
order you specify here) to the DHCP clients. The EMG2306-R10A only passes this
information to the LAN DHCP clients when you select the Enable DHCP Server check
box. When you clear the Enable DHCP Server check box, DHCP service is disabled
and you must have another DHCP sever on your LAN, or else the computers must have
their DNS server addresses manually configured.