Chapter 9 Wireless LAN
EMG2306-R10A User’s Guide
81
9.6.1 More AP Edit
Use this screen to edit an SSID profile. Click the Edit icon next to an SSID in the Configuration >
Network > Wireless LAN > More AP screen. The following screen displays.
Figure 37 Wireless LAN > More AP: Edit
The following table describes the labels in this screen.
9.7 MAC Filter
The MAC filter screen allows you to configure the EMG2306-R10A to give exclusive access to
devices (Allow) or exclude devices from accessing the EMG2306-R10A (Deny). Every Ethernet
device has a unique MAC (Media Access Control) address. The MAC address is assigned at the
Table 27 Wireless LAN > More AP
LABEL DESCRIPTION
Wireless Setup
Active Click the check box to activate wireless LAN.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Intra-BSS Traffic Intra-BSS traffic is traffic between wireless stations in the BSS. Select this check box to
enable Intra-BSS Traffic.
WMM QoS Check this to have the EMG2306-R10A automatically give a service a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi
MultiMedia Quality of Service) gives high priority to voice and video, which makes them
run more smoothly.
Security
Security This field indicates the security mode of the SSID profile.
Apply Click Apply to save your changes back to the EMG2306-R10A.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
