Chapter 9 Wireless LAN
EMG2306-R10A User’s Guide
82
factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You
need to know the MAC address of the devices to configure this screen.
To change your EMG2306-R10A’s MAC filter settings, click Configuration > Network > Wireless
LAN > MAC Filter. The screen appears as shown.
Figure 38 Configuration > Network > Wireless LAN > MAC Filter
The following table describes the labels in this menu.
Table 28 Configuration > Network > Wireless LAN > MAC Filter
LABEL DESCRIPTION
SSID Select Select the SSID for which you want to configure MAC filtering.
MAC Address Filter Select Disable to deactivate the MAC filtering rule you configure below.
Filter Action Select Allow to permit access to the EMG2306-R10A, MAC addresses not listed will be
denied access to the EMG2306-R10A.
Select Deny to block access to the EMG2306-R10A, MAC addresses not listed will be
allowed to access the EMG2306-R10A
MAC Filter Summary
Set This is the index number of the MAC address.
MAC Address This is the MAC address of the wireless station that are allowed or denied access to the
EMG2306-R10A.
To Next Page
Loading...
